How To Replace Bathroom Faucet Drain

How to Replace a Bathroom Faucet Drain

A leaky faucet drain can waste gallons of water and damage your bathroom vanity. Replacing a faucet drain is a relatively simple project that can be completed in about 30 minutes. Here's a step-by-step guide on how to do it:

What You'll Need:

New faucet drain
Adjustable wrench
Plumber's putty
Rags or towels
Bucket

Step 1: Turn Off the Water Supply

Locate the water supply valves under the sink and turn them off. The valves are usually located near the base of the faucet.

Step 2: Remove the Old Drain

Place a bucket under the drain to catch any water that may leak out. Use an adjustable wrench to loosen the nut that holds the drain in place. Once the nut is loose, you can remove the old drain by hand.

Step 3: Apply Plumber's Putty

Roll a small amount of plumber's putty into a rope and place it around the base of the new drain. The putty will help to create a watertight seal.

Step 4: Insert the New Drain

Insert the new drain into the hole in the sink. Hand-tighten the nut to secure the drain in place.

Step 5: Tighten the Nut

Use the adjustable wrench to tighten the nut. Do not overtighten the nut, as this can damage the drain or the sink.

Step 6: Turn On the Water Supply

Turn on the water supply valves under the sink. Check for leaks around the drain. If you see any leaks, tighten the nut a bit more.

Step 7: Clean Up

Wipe up any water that may have spilled during the repair. Dispose of the old drain and any leftover plumber's putty.

Replacing a bathroom faucet drain is a simple project that can save you money and prevent water damage. By following these steps, you can easily replace your old drain and get your faucet working properly again.