How To Replace A Bathroom Faucet

Replacing a bathroom faucet is a relatively easy home improvement project that can be completed in a few hours. By following these step-by-step instructions, you can save yourself the cost of hiring a plumber. Before you begin, it is essential to turn off the water supply to the faucet. This can be done by turning off the valve located beneath the sink or by closing the main water valve for your home.

Tools and materials you will need

New faucet
Adjustable wrench
Basin wrench
Plumber's putty
Teflon tape
Screwdriver
Bucket

Instructions

Remove the old faucet: Using an adjustable wrench, loosen the nuts that are holding the faucet in place. Be careful not to overtighten the nuts, as this can damage the faucet. Once the nuts are loose, remove the faucet from the sink.
Clean the sink: Once the old faucet is removed, clean the sink around the faucet holes. This will remove any old sealant or debris that could interfere with the installation of the new faucet.
Apply plumber's putty: Roll out a small amount of plumber's putty and form it into a rope. Place the rope of putty around the base of the new faucet.
Install the new faucet: Place the new faucet in the sink and tighten the nuts that are holding it in place. Be sure to tighten the nuts just enough so that the faucet is secure but not overtightened.
Install the handles: Install the handles on the faucet by screwing them onto the stems. Tighten the handles just enough so that they are secure but not overtightened.
Connect the water supply: Connect the water supply lines to the faucet. Be sure to use Teflon tape on the threads of the water supply lines to prevent leaks.
Turn on the water supply: Turn on the water supply and check for leaks. If you find any leaks, tighten the nuts or water supply lines until the leaks stop.

Tips

To prevent leaks, make sure that all of the connections are tight. However, avoid overtightening the nuts, as this can damage the faucet.
If you have any difficulty removing the old faucet, you may need to use a basin wrench. A basin wrench is a specialized tool that is designed to loosen the nuts that hold the faucet in place.
If you are replacing a faucet with a different type of faucet, you may need to make some modifications to the sink. For example, if you are replacing a two-handle faucet with a single-handle faucet, you will need to drill a hole in the sink for the new faucet handle.

Conclusion

Replacing a bathroom faucet is a relatively simple plumbing project that can be completed in a matter of hours. By following these step-by-step instructions, you can save yourself the cost of hiring a plumber and enjoy the satisfaction of completing the project yourself.