How To Remove Faucet From Bathroom Sink

A step-by-step guide to remove a bathroom faucet

Replacing a bathroom faucet is a relatively simple task that can be completed in about an hour. Before you start, be sure to turn off the water supply to the sink and open the faucet to release any remaining water. You will need a few tools to complete this task:

Adjustable wrench
Allen wrench
Phillips screwdriver
Flathead screwdriver
Bucket

1. Open the shut off valves under sink

The first step is to open the shut off valves under the sink. These valves are usually located near the base of the faucet and will have a handle that you can turn to turn off the water. Once the valves are closed, open the faucet to release any remaining water.

2. Disconnect the water supply lines

Once the water is off, you can disconnect the water supply lines. These lines are usually attached to the faucet with nuts or bolts. Use an adjustable wrench to loosen the nuts or bolts and then disconnect the lines.

3. Remove the nuts holding the faucet in place

Underneath the sink, there will be nuts holding the faucet in place. Use an adjustable wrench to loosen these nuts. Be careful not to overtighten the nuts, as this can damage the faucet.

4. Remove the faucet

Once the nuts are loose, you can remove the faucet. Gently pull the faucet up and out of the sink. Be careful not to damage the sink or the faucet.

5. Clean the sink and the faucet

Once the faucet is removed, take some time to clean the sink and the faucet. Use a mild detergent and a soft cloth to clean the surfaces. Rinse the sink and the faucet thoroughly with water.

6. Install the new faucet

Now that the sink and the faucet are clean, you can install the new faucet. Reverse the steps that you took to remove the old faucet. Be sure to tighten the nuts securely, but do not overtighten them.

7. Reconnect the water supply lines

Once the faucet is installed, you can reconnect the water supply lines. Tighten the nuts or bolts that secure the lines to the faucet. Be sure to tighten the nuts or bolts securely, but do not overtighten them.

8. Open the shut off valves and turn on the faucet

Once the water supply lines are connected, you can open the shut off valves and turn on the faucet. Check for leaks and tighten any loose connections.