How To Install New Bathroom Faucet

How to Install a New Bathroom Faucet

Upgrading your bathroom faucet is a relatively easy project that can give your bathroom a whole new look. It's also a great way to save money on your water bill, as new faucets are often more water-efficient than older models.

If you're not comfortable working with plumbing, it's best to leave faucet installation to a professional. However, if you're handy and have some basic plumbing tools, you should be able to do it yourself in a few hours.

Tools and Materials You'll Need

* New bathroom faucet * Adjustable wrench * Plumber's putty * Teflon tape * Rags * Bucket

Step-by-Step Instructions

1. Turn off the water supply. There are usually two shut-off valves under the sink, one for hot water and one for cold water. Turn both valves clockwise to shut off the water supply. 2. Disconnect the old faucet. Use the adjustable wrench to loosen the nuts that hold the old faucet in place. Be careful not to overtighten the nuts, as this can damage the faucet. Once the nuts are loose, you can pull the old faucet out of the sink. 3. Clean the sink surface. Use a rag and some cleaner to clean the surface of the sink where the new faucet will be installed. This will help to ensure a good seal. 4. Apply plumber's putty. Roll out a small piece of plumber's putty and form it into a ring. Place the ring of putty around the base of the new faucet. This will help to seal the faucet and prevent leaks. 5. Wrap Teflon tape around the threads. Wrap several layers of Teflon tape around the threads of the faucet's mounting bolts. This will help to create a watertight seal. 6. Install the new faucet. Insert the new faucet into the sinkhole and tighten the mounting bolts by hand. Use the adjustable wrench to tighten the bolts further, but be careful not to overtighten them. 7. Connect the water supply lines. Attach the hot and cold water supply lines to the corresponding valves on the new faucet. Use the adjustable wrench to tighten the nuts on the water supply lines. 8. Turn on the water supply. Slowly turn on the shut-off valves under the sink to restore the water supply. Check for leaks around the base of the faucet and the water supply lines. If you find any leaks, tighten the nuts or bolts until the leaks stop.

Tips

* If you're not sure which way to turn the shut-off valves, try turning them both clockwise. If the water supply doesn't turn off, try turning them both counterclockwise. * If you have trouble getting the old faucet out of the sink, you can use a penetrating oil to loosen the nuts. * Be careful not to overtighten the mounting bolts, as this can damage the faucet. * If you're not comfortable working with plumbing, it's best to leave faucet installation to a professional.