How To Install Drain In Bathroom Sink

Installing a drain in a bathroom sink is a relatively simple plumbing task that can be completed in a few hours. By following these step-by-step instructions, you can save yourself the cost of hiring a plumber and enjoy the satisfaction of completing the project yourself.

Materials You'll Need:

Pop-up drain assembly
Plumber's putty
Wrench
Screwdriver
Bucket
Rags

Step-by-Step Instructions:

1. Remove the old drain assembly.

Place a bucket under the sink to catch any water that may leak out. Use a wrench to loosen the nuts that hold the drain assembly in place. Once the nuts are loose, you can remove the old drain assembly by hand.

2. Clean the drain hole.

Use a rag to clean the drain hole of any debris. Make sure that the drain hole is free of any obstructions so that the new drain assembly can fit properly.

3. Apply plumber's putty.

Roll a small piece of plumber's putty into a rope and place it around the base of the new drain assembly. The plumber's putty will help to create a watertight seal between the drain assembly and the sink.

4. Install the new drain assembly.

Insert the new drain assembly into the drain hole and tighten the nuts until they are snug. Do not overtighten the nuts, as this could damage the drain assembly.

5. Connect the drainpipe.

Connect the drainpipe to the outlet of the drain assembly. The drainpipe will carry the wastewater from the sink to the drain.

6. Test the drain.

Turn on the water and let it run for a few minutes. Check for any leaks around the drain assembly. If you see any leaks, tighten the nuts until the leaks stop.

Tips:

If you are not comfortable working with plumbing, it is best to hire a licensed plumber to install the drain for you.
Be sure to turn off the water supply to the sink before you begin working on the drain.
Wear gloves and safety glasses when working with plumbing.
If you have any questions about installing a drain, consult a qualified plumber.