How To Install A Bathroom Sink Faucet

How to Install a Bathroom Sink Faucet

Replacing a bathroom sink faucet is a relatively simple plumbing project that can be completed in a few hours. By following a few simple steps, you can save yourself the cost of hiring a plumber.

Step 1: Gather Your Materials

Before you begin, gather all of the materials you will need for the installation. These include:

A new bathroom sink faucet
A basin wrench
A pair of pliers
A flashlight
A bucket
Plumber's putty
Teflon tape

Step 2: Turn Off the Water Supply

Once you have gathered your materials, the first step is to turn off the water supply to the sink. This is typically done by turning the valves located under the sink. If there are no valves, you will need to turn off the main water supply to your home.

Step 3: Remove the Old Faucet

Once the water supply is turned off, you can begin removing the old faucet. Start by disconnecting the water supply lines from the faucet. Use the pliers to loosen the nuts that hold the lines in place. Be careful not to overtighten the nuts, as this can damage the lines.

Once the water supply lines are disconnected, you can remove the faucet from the sink. Use the basin wrench to loosen the nuts that hold the faucet in place. Again, be careful not to overtighten the nuts.

Step 4: Prepare the New Faucet

Before you install the new faucet, you need to prepare it. Start by wrapping the threads of the water supply lines with Teflon tape. This will help to create a watertight seal.

Next, apply a bead of plumber's putty around the base of the faucet. This will help to seal the faucet to the sink and prevent leaks.

Step 5: Install the New Faucet

Now you can install the new faucet. Start by placing the faucet in the sinkhole. Make sure that the faucet is centered and that the handles are facing the correct direction.

Next, tighten the nuts that hold the faucet in place. Again, be careful not to overtighten the nuts.

Step 6: Connect the Water Supply Lines

Once the faucet is installed, you can connect the water supply lines. Start by connecting the hot water line to the hot water supply valve. Then, connect the cold water line to the cold water supply valve.

Use the pliers to tighten the nuts that hold the water supply lines in place. Again, be careful not to overtighten the nuts.

Step 7: Turn On the Water Supply

Once the water supply lines are connected, you can turn on the water supply. Start by slowly opening the valves under the sink. Then, check for leaks. If there are any leaks, tighten the nuts that hold the water supply lines in place.

Step 8: Enjoy Your New Faucet

Once you have installed your new faucet, you can enjoy the benefits of a new and updated look. You can also rest assured that you have saved yourself the cost of hiring a plumber.