How To Fix Bathroom Sink Stopper

A bathroom sink stopper is a small device that plugs the drain hole in a sink. It is typically made of rubber or plastic, and it is designed to prevent water from flowing out of the sink. Sink stoppers can become clogged with hair, soap scum, and other debris, which can cause them to stop working properly. If your bathroom sink stopper is not working properly, there are a few things you can do to fix it.

1. Clean the stopper

The first step is to clean the stopper. To do this, remove the stopper from the sink and rinse it with water. If the stopper is clogged with hair or soap scum, you can use a toothbrush to scrub it clean. Once the stopper is clean, rinse it again with water and replace it in the sink.

2. Lubricate the stopper

If the stopper is still not working properly, you may need to lubricate it. To do this, apply a small amount of petroleum jelly or silicone grease to the rim of the stopper. This will help to create a seal between the stopper and the sink, which will prevent water from leaking out.

3. Replace the stopper

If the stopper is still not working properly, you may need to replace it. To do this, remove the old stopper from the sink and replace it with a new one. Make sure that the new stopper is the correct size for your sink.

4. Adjust the stopper

If the stopper is still not working properly, you may need to adjust it. To do this, remove the stopper from the sink and turn it upside down. There is a small screw on the bottom of the stopper. Turn the screw clockwise to tighten the stopper or counterclockwise to loosen it. Replace the stopper in the sink and test it to make sure that it is working properly.

5. Call a plumber

If you have tried all of the above steps and the stopper is still not working properly, you may need to call a plumber. A plumber can diagnose the problem and repair or replace the stopper.

Here are some additional tips for fixing a bathroom sink stopper:

If the stopper is made of rubber, you can try boiling it in water for a few minutes. This will help to soften the rubber and make it more pliable.
If the stopper is made of plastic, you can try soaking it in a solution of vinegar and water. This will help to dissolve any soap scum or mineral deposits that may be clogging the stopper.
If the stopper is still not working properly, you can try using a plunger to dislodge any blockages.
If all else fails, you can always call a plumber to fix the stopper.

By following these tips, you can fix a bathroom sink stopper and get it working properly again.