How To Fix Bathroom Faucet

A leaking faucet is a common plumbing problem that can waste a lot of water and increase your water bill. If you're not comfortable fixing it yourself, you can call a plumber. But if you're handy and have a few basic tools, you can probably fix it yourself in about an hour.

Here's a step-by-step guide on how to fix a leaking bathroom faucet:

1. Gather your tools and materials.

You will need the following tools and materials:

Adjustable wrench
Phillips screwdriver
Flathead screwdriver
Replacement faucet washer
Plumber's putty
Rags

2. Turn off the water supply to the faucet.

The first step is to turn off the water supply to the faucet. There are usually two shut-off valves under the sink. Turn both valves clockwise to turn off the water.

3. Remove the aerator.

The aerator is the small screen on the end of the faucet. It helps to mix air with water to create a more forceful stream. To remove the aerator, unscrew it counterclockwise by hand or with a wrench.

4. Remove the handle.

Once the aerator is removed, you can remove the handle. There is usually a small screw on the side of the handle. Remove the screw and pull the handle straight up to remove it.

5. Remove the packing nut.

The packing nut is located under the handle. It is a large nut that holds the faucet in place. To remove the packing nut, use an adjustable wrench to turn it counterclockwise.

6. Remove the faucet stem.

The faucet stem is located inside the packing nut. To remove the faucet stem, use a screwdriver to remove the screw that holds it in place. Then, pull the faucet stem straight up to remove it.

7. Inspect the faucet washer.

The faucet washer is a small rubber washer that sits on the end of the faucet stem. It creates a seal between the faucet stem and the faucet body. If the faucet washer is worn or damaged, it can cause the faucet to leak.

8. Replace the faucet washer.

If the faucet washer is worn or damaged, you will need to replace it. To do this, simply remove the old washer and replace it with a new one.

9. Reassemble the faucet.

Once you have replaced the faucet washer, you can reassemble the faucet. To do this, simply reverse the steps that you took to disassemble it.

10. Turn on the water supply and check for leaks.

Once the faucet is reassembled, turn on the water supply and check for leaks. If there are any leaks, tighten the packing nut or the handle until the leak stops.

Fixing a leaking bathroom faucet is a relatively simple task that can be completed in about an hour. By following these steps, you can save yourself the cost of calling a plumber.