How To Change Bathroom Tub Faucet

A leaking or broken bathroom tub faucet can be a major inconvenience, wasting water and potentially causing damage to your bathroom. While it may seem like a daunting task, changing a bathroom tub faucet is actually a relatively simple plumbing project that can be completed in a few hours with the right tools and materials. Here's a step-by-step guide to help you replace your bathroom tub faucet:

Tools and Materials

Replacement faucet
Adjustable wrench
Basin wrench
Plumber's putty
Teflon tape
Bucket
Flashlight

Step-by-Step Instructions

1. Turn off the water supply.

The first step is to turn off the water supply to the faucet. There will be two shut-off valves underneath the sink, one for hot water and one for cold water. Turn the valves clockwise to shut off the water.

2. Disconnect the old faucet.

Once the water supply is turned off, you can disconnect the old faucet. Use an adjustable wrench to loosen the nuts that hold the faucet in place. Once the nuts are loose, you can pull the faucet straight up to disconnect it from the water supply lines.

3. Apply plumber's putty to the new faucet.

Before you install the new faucet, you need to apply plumber's putty to the base of the faucet. Plumber's putty is a pliable material that helps to create a watertight seal between the faucet and the sink. Roll out a small piece of plumber's putty and form it into a ring around the base of the faucet.

4. Wrap Teflon tape around the threads of the water supply lines.

Next, you need to wrap Teflon tape around the threads of the water supply lines. Teflon tape helps to create a watertight seal between the faucet and the water supply lines. Wrap the Teflon tape clockwise around the threads, starting from the bottom and working your way up. Make sure to overlap the tape by at least half of its width.

5. Connect the new faucet to the water supply lines.

Now you can connect the new faucet to the water supply lines. Hand-tighten the nuts that hold the faucet in place, then use an adjustable wrench to tighten the nuts further. Make sure not to overtighten the nuts, as this could damage the faucet or the water supply lines.

6. Turn on the water supply and check for leaks.

Once the new faucet is installed, turn on the water supply and check for leaks. If there are any leaks, tighten the nuts further or add more plumber's putty to the base of the faucet. Once the faucet is leak-free, you can enjoy your new bathroom tub faucet.