How Do I Replace A Bathroom Faucet

How Do I Replace a Bathroom Faucet?

If your bathroom faucet is dripping, leaking, or simply outdated, replacing it is a relatively easy and inexpensive DIY project that can update the look of your bathroom and improve its functionality. Here's a step-by-step guide to help you replace your bathroom faucet:

Step 1: Gather Your Tools and Materials

Before you begin, gather the following tools and materials:

New bathroom faucet
Adjustable wrench
Basin wrench
Teflon tape
Plumber's putty
Bucket or bowl
Screwdriver (optional)

Step 2: Turn Off the Water Supply

Once you have your tools and materials, turn off the water supply to the faucet. There should be two shut-off valves under the sink. Turn the valves clockwise to close them.

Step 3: Disconnect the Old Faucet

Use the basin wrench to loosen the nuts that hold the faucet to the sink. Be careful not to overtighten the nuts, as this can damage the faucet or the sink.

Once the nuts are loose, remove the old faucet by pulling it straight up. There may be some water left in the faucet, so be sure to have a bucket or bowl ready to catch it.

Step 4: Clean the Sink

Before installing the new faucet, clean the sink around the faucet holes. This will help ensure a good seal and prevent leaks.

Step 5: Install the New Faucet

Apply a thin bead of plumber's putty around the base of the new faucet. This will help seal the faucet and prevent leaks.

Insert the new faucet into the sink holes and hand-tighten the nuts that hold it in place. Use the basin wrench to further tighten the nuts, but be careful not to overtighten them.

Step 6: Connect the Water Lines

Attach the water lines to the new faucet. Make sure to use Teflon tape on the threads of the water lines to ensure a good seal.

Tighten the nuts on the water lines using the adjustable wrench. Again, be careful not to overtighten them.

Step 7: Turn on the Water Supply and Check for Leaks

Turn on the water supply to the faucet and check for leaks. If there are any leaks, tighten the nuts on the water lines or faucet until the leak stops.