Rv Bathroom Vent Fan Replacement

RV Bathroom Vent Fan Replacement

If your RV bathroom vent fan is making noise, not working properly, or not ventilating effectively, it may be time to replace it. Replacing an RV bathroom vent fan is a relatively simple DIY project that can be completed in a few hours. Here are the steps on how to do it:

Step 1: Gather the necessary tools and materials

You will need the following tools and materials to replace your RV bathroom vent fan:

New RV bathroom vent fan
Screwdriver
Wire cutters
Electrical tape
Butyl tape

Step 2: Remove the old vent fan

To remove the old vent fan, first turn off the power to the fan at the circuit breaker. Then, remove the screws that are holding the fan in place. Carefully pull the fan out of the opening.

Step 3: Disconnect the old vent fan

Once the fan is removed, disconnect the wires that are connected to it. Use wire cutters to cut the wires, and then use electrical tape to insulate the ends of the wires.

Step 4: Install the new vent fan

To install the new vent fan, first apply a bead of butyl tape around the perimeter of the new fan. Then, insert the new fan into the opening and screw it into place. Connect the wires from the new fan to the wires from the RV's electrical system, using electrical tape to insulate the connections.

Step 5: Test the new vent fan

Once the new vent fan is installed, turn on the power to the fan at the circuit breaker. The fan should start running immediately. Check to make sure that the fan is ventilating properly by holding a piece of paper up to the fan. The paper should be sucked into the fan.

Tips for replacing an RV bathroom vent fan

When choosing a new vent fan, make sure to select one that is the same size as the old fan. This will ensure that the fan will fit properly in the opening.
If you are not comfortable working with electrical wiring, it is best to hire a qualified electrician to replace the vent fan for you.
Butyl tape is a sticky, waterproof tape that is used to seal the edges of the vent fan. It is important to apply a bead of butyl tape around the perimeter of the new fan before installing it.

Conclusion

Replacing an RV bathroom vent fan is a relatively simple DIY project that can be completed in a few hours. By following the steps in this article, you can easily replace your old vent fan and keep your RV bathroom well-ventilated.