How To Replace Bathroom Faucet

How to Replace a Bathroom Faucet

Replacing a bathroom faucet is a relatively simple plumbing task that can be completed in a few hours. With a few basic tools and a little bit of know-how, you can save yourself the cost of hiring a plumber.

Here are the steps on how to replace a bathroom faucet:

1. Gather your tools and materials

You will need the following tools and materials:

Phillips screwdriver
Adjustable wrench
Basin wrench
New faucet
Plumber's putty
Teflon tape

2. Turn off the water supply

The first step is to turn off the water supply to the faucet. There will be two shut-off valves under the sink, one for the hot water and one for the cold water. Turn both valves clockwise to turn off the water.

3. Disconnect the old faucet

Once the water supply is turned off, you can disconnect the old faucet. Start by removing the aerator, which is the small screen at the end of the faucet spout. Use a wrench to loosen the aerator and then unscrew it by hand.

Next, disconnect the water supply lines from the faucet. Use an adjustable wrench to loosen the nuts that hold the water supply lines in place. Once the nuts are loose, you can disconnect the water supply lines by hand.

Finally, remove the mounting nuts that hold the faucet in place. The mounting nuts are usually located under the sink. Use an adjustable wrench to loosen the mounting nuts and then remove the faucet by hand.

4. Clean the sink

Once the old faucet is removed, you should clean the sink. Use a damp cloth to wipe away any dirt or debris. This will help to ensure that the new faucet fits properly.

5. Install the new faucet

Now you are ready to install the new faucet. Start by applying a bead of plumber's putty around the base of the faucet. The plumber's putty will help to create a seal between the faucet and the sink.

Next, insert the faucet into the sink. Make sure that the faucet is centered and that the spout is facing the correct direction. Tighten the mounting nuts to secure the faucet in place.

Finally, connect the water supply lines to the faucet. Use Teflon tape to wrap around the threads of the water supply lines. This will help to prevent leaks.

6. Turn on the water supply

Once the new faucet is installed, you can turn on the water supply. Open the shut-off valves under the sink to turn on the water. Check for leaks around the faucet. If you see any leaks, tighten the mounting nuts or the water supply lines until the leak stops.

7. Test the faucet

Once the faucet is installed and there are no leaks, you should test the faucet. Run the water through the faucet to make sure that the water flows properly. Check the temperature of the water to make sure that the hot and cold water are mixed correctly.

Replacing a bathroom faucet is a relatively simple plumbing task that can be completed in a few hours. By following these steps, you can save yourself the cost of hiring a plumber.